Laser HDPE HX 17 is a rigid, very good free flowing Laser Sinter powder. Suitable for parts from above 1,5mm. 100% reusable. No blending and mixing of old and new powder. It can be varnished with comon plastic paint. Consistent against acid and base, water, alcohol, oil and gasoline. It can be welded and crosslinked. Very smooth surface, epecially suitable for masterforms for vacuum casting. Medium particle size:50µm. Max.particle size: 80µm. Recomended layerheight: 100µm

Density:0,97g/cm3ISO 1183 A
Apparent Density:0,5 g/cm3DIN 53 466
Melt Flow Index MFI:20
g/10 minISO 1133
Lineare Schwindung:
Average Particle Size:50
Mechanical Properties of laser sintered parts:

Tensile Strength x:        21MPa ISO 178
Tensile Strength z:
MPa ISO 178
Tensile Modulus x:                           2000MPa ISO 178
Tensile Modulus z:                             
MPa ISO 178
Elongation at Break x:                         5,5
% ISO 178
Elongation at Break z: 
%               ISO 178
IZOD Impact Strengt 23°C  8,510 kJ/m2 ISO 180
Shore D
NmDIN 53505
Thermal Properties:

Vicat A: 75
°CISO 306
Melting Temperature:              130°CDIN 53 736





The material data are obtained our best knowledge and experience. They do not on their own represent a sufficient basis for any part design, neither do they provide any agreement about or guarantee the specific properties of a product or part or the suitability of a product or part for a specific application. It is the responsibility of the producer or customer of a part to check its properties as well as its suitability for a particular purpose. This also applies regarding the consideration of possible intellectual property rights as well as laws and regulations. The data are subject to change without notice as part of the continuous development and improvement processes of Diamond Plastics.

» zurück